F un gift/treat box made with Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a cutting and scoring tool:
- 2" x 4-1/4" Rococo Rose Cardstock
- 1-3/4" x 3-1/4" from Terracotta Tile Cardstock
- 1-3/4" x 3-1/4" from Rococo Rose Cardstock
- 1" x 2" of mottled pink, tan, and orange pink with faint white medallions textile design from Woven Threads Designer Series Paper
Fold the box together on the crease lines. Insert treats and close the box up. Use small strips of the Stampin' Up! logo washi tape from the Follow Your Art Washi Tape to make sure the box stays closed.
Unlock the Delightful Tag Topper Punch. Slide one short end of the 2" x 4-1/4" Rococo Rose strip into the punch as far as it will go and punch. Leave the punch unlocked.
Adhere the strip of Woven Threads Designer Paper to the unpunched bottom of the tag.
Slide the short end of the Rococo Rose strip with the designer paper attached into the punch as far as it will go and punch.
Use a cutting and scoring tool or Paper Snips to cut off the bottom of the tag with the designer paper on it so the hole is cut off and only the one bump is left.
Mount the "Love to celebrate you" sentiment stamp on Block C. Ink it up with the Terracotta Tile Ink Pad. Stamp it in the center of the tag just above the designer paper.
Mount the large, flat, open-wing butterfly from the Butterfly Wishes Set to Block C. Ink it up with the Terracotta Tile Ink Pad. Stamp it on the strip of 1-3/4" x 3-1/4" Rococo Rose Cardstock near one end.
Unlock the Butterfly Duet Punch. Hold the punch upside down so you can see the punching area. Get the butterfly image centered in the corresponding punching area. Punch. Leave the punch unlocked.
Slide the strip of Terracotta Tile Cardstock into the unlocked Butterfly Duet Punch and punch out a large butterfly. Leave the punch unlocked.
Mount the small, flat, open-wing butterfly from the Butterfly Wishes Set to Block A. Ink it up with the Terracotta Tile Ink Pad. Stamp it on the other end of the strip of punched Rococo Rose Cardstock.
Hold the unlocked Butterfly Duet Punch upside down so you can see the punching area. Get the small butterfly image centered in the corresponding punching area. Punch.
Use a Mini Stampin' Dimensional to adhere the small butterfly punch out to the bottom left side of the tag at a slight angle so it overlaps the seam between the cardstock and designer paper a bit.
Use Paper Snips to cut the body out from between the wings off the Terracotta Tile butterfly punch out.
Adhere the Terracotta Tile wing cut outs to the back of the Rococo Rose butterfly punch out so the Terracotta Tile shows just a bit on both sides of the Rococo Rose butterfly.
Use a Stampin' Dimensional to adhere the layered butterfly punch out to the top of the tag in the center.
Tie some Rococo Rose 1/2" Gathered Ribbon around your gift box on the left side using a knot. Trim the ends.
Cut a 6" piece of Linen Thread.
Fold the thread in half. Stick the folded ends of the thread through the ribbon hole in the top of the tag from the front side. Feed the two loose ends of the thread through the loop in the twine and pull it tight.
Tie the two loose ends of the thread to the knot in the ribbon using a small bow. Trim the ends.