Q uick and easy birthday card using Stampin' Up! products including some that can be earned for FREE during Sale-A-Bration 2024.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer and Paper Snips Scissors:
- card from Poppy Parade Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" peg board design from Trusty Toolbox 12" x 12" Designer Series Paper
- 1" x 5-1/4" of blue and white grid paper design from Trusty Toolbox 12" x 12" Designer Series Paper
- various tools cut out with Paper Snips Scissors from Trusty Toolbox 12" x 12" Designer Series Paper designs
Mount the "Enjoy Your Day" sentiment from the Heartfelt Hellos Set on Block C. Ink it up with the Poppy Parade Ink Pad. Stamp it on the right side of the horizontal grid paper Trusty Toolbox Designer Paper strip.
Adhere the stamped grid paper designer paper strip to the bottom of the horizontal peg board Trusty Toolbox Designer Paper rectangle so it is about 1/2" from the bottom.
Adhere the layered peg board designer paper to the front of the Poppy Parade card.
If you haven't done so yet, use Paper Snips Scissors to cut out various tools by hand from the Trusty Toolbox Designer Paper.
Without adhering, lay the cut out tools on the card front to figure out spacing and layout.
If desired, use the Cajun Craze Stampin' Write Marker to fill in any white holes in the designer paper cut outs.
Use Stampin' Seal, Multipurpose Liquid Glue or Fine-Tip Glue Pen, and Stampin' Dimensionals to adhere the cut out tools in place to the front of the card.
Use the mini spatula on the Take Your Pick to carefully peel up 1 large and 2 small copper dots from the sheet of Brushed Metallic Dots making sure that you get the adhesive backings as well. Adhere them in a straight line in the upper right corner of the card as shown so the large dot is in the center and they are evenly spaced.